10.5.4

Ecessa Firmware Release Notes
Version: 10.5.4
Release Date: 2016.03.07
Revision 1.0: 2016.03.07

Fixes
1. When connecting to a PPTP server behind the Ecessa with WAN Virtualization enabled the device can become unresponsive.

Known Issues
1. WAN Virtualization hub location cannot have a site number that is greater than 127.
2. IPSec VPN failover test point type 'Manual IP Configuration' does not work as expected.
3. IPSec IKEv2 security associations to Cisco devices not properly passing traffic on all subnets.
4. Deleting a QoS classifier from the GUI might not work properly.
5. IPSec VPN Failback option does not work as expected.
6. When changing static routes that use aliases there is a small possibility that traffic could continue using the WAN over which it was previously routed.
7. Ports can become disabled on legacy 600 product (7568c) when pulling a cable during traffic flow.
8. All comment sections throughout command line and web interface should not allow invalid characters.
9. L2TP VPN connections can fail to establish after activating changes to another VPN connection.
10. VTI VPN which is behind NAT will not be able to connect.
11. Device can restart after a period of time when the sites tunnel configurations do not match.
12. Deleting and then re-adding a VPN via the command line interface can cause the VTI VPNs to not work correctly.